
Wavecom Instruments Fully Integrated Test n Print Unit User Manual
4
Important Information
Contents
Integrated Test N Print System
User Manual IEC Test Lead (500mm Orange)
WCM Keyboard USB – PC Cable
Wavecom Scanner Scanner Cable
Wavecom TT Barcode Printer 2 x Rolls /500 Labels - 2 x Resin Ribbons
WinPATS Software (Full Version - Asset Management) Earth Lead with Alligator Clip (1800mm black)
Self Contained in Heavy Duty Case Locking IEC Power Cable (1800mm Blue)
Manufacturer’s 1
st
Calibration Certificate
(Valid for 12 months from date of purchase)
Important: Please Register your WinPATS Software and Test n Print Unit with the provided
documentation or online via our website www.wavecom.com.au
Precautions
Note: 10A ver. plug illustrated. 20A ver. is similar.
Manufacturer Recommendations
Calibration:
The AS/NZS3760:2010 Standard recommends a routine calibration / verification of this unit to
ensure the accuracy of readings on a 12 monthly basis, or as prescribed under any additional local Regulatory
requirements.
Note: Only Wavecom Instruments or its Authorised Service Agents are permitted to repair and Calibrate this
Instrument. Failure to perform unauthorised service or repair may void all warranties and Calibration Status.
Safety Warning
This 4
th
Generation TnP series of products have been designed to meet stringent safety requirements, however
no device can completely protect persons from the consequences of incorrect use.
The testing of Electrical appliances requires that extra care and caution is taken at all times to ensure personal
safety.
The Manufacturer also advises that appliance testing should be conducted by a Competent and suitably trained
person, as referred to under the current Standard AS3760:2010, as well as any additional legislation or rulings in
different states.
If in doubt, the manufacturer suggests the user contact their responsible Authority.
For maximum safety, always ensure that the following advice is followed:
The equipment being tested is in good condition / visual check.
All user instructions are followed.
Double check power supply connections. (note LED status)
Unique Locking Power Cable:
Please make sure yellow lever is depressed prior to removal
of the locking power supply cable - 10A & 20A Models.
Failure to do so, combined with excessive force may damage
the rear panel.
This revolutionary locking, removable cable is intended
not to dislodge during test procedures.
Comentários a estes Manuais