Wavecom Instruments Fully Integrated Test n Print Unit User Manual
11
Powering on the Tester
When the tester is powered on the scanner will beep a few times indicating the scanner is also powered. If no
beep is heard check the PS2 connections from the tester.
Initially the printer’s status light will be orange but after about 5-10 seconds it will change to green. The tester will
not print unless the printer light is solid green. A flashing red status light can indicate a media or general printer
fault.
Note 1: If the TnP stays locked on the logo screen please check the connectivity of keyboard & scanner cables.
The TnP unit will not work with scanner only connected. The TnP system requires either Keyboard only, or both
Keyboard & Scanner to be connected.
Note 2: If no devices are connected to the interface, the unit will function as a normal TnT tester.
Adding New Equipment
The following must be done before testing:
Create a site or use and existing site.
Create a user name to under the users list.
If auto generate number is used the initial number must be set correctly.
If you are adding equipment to an existing site please make sure that the correct site is displayed. If the
wrong site is displayed the equipment will be assigned to the wrong site.
When the testers memory has been erased it will look like the following screen.
< F1 Select Site
New Barcode
0000000 5000
When the initial screen in memory mode operation is displayed. A site and user
must be entered before testing can be done. When using the TnP for the first time,
< F1 Select Site will be flashing in the top region of the screen.
Adding a Site
From the initial screen, press F1. Don't hold the F key, this will select a different
function.
The TnP can hold up to 16 sites. To scroll through the sites, press enter. 3 sites
will be shown on each screen. Each site corresponds to an "F" key, for example
Site 1 = F1. To edit a site, hold the corresponding "F" key for 2 seconds. If the
Site has a * symbol next to the name then the site name cannot be altered. This
site was uploaded from WinPATS and needs to remain the same.
Using the keypad, enter the name of the site. The Keypad operates in 3 modes-
Alpha, Numeric and Predictive. When an editable screen is entered, there will be
an ALP, NUM or PRE in the top right hand corner of the screen. If you are using a
full size half size keyboard then the 3 modes don't apply. Leave the text on ALP
mode. Once the details have been typed in press enter to return.
Note: Predictive mode will only work if a dictionary has been uploaded from
WinPATS . Once a site has been entered, press enter.
Sites 1 - 3
Site 1
Site 2
Site 3
Once a site has been entered, the 'F' buttons are used to select the site. For
example to select site 1, F1 would be pressed.
Site 1
New Barcode
0000000 5000
Once a site has been selected, the TnP will return to the initial screen and the site
that was selected will be shown in the top left hand corner of the screen.
(13 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais