Wavecom TT040-50 Manual do Utilizador descarregar pdf (Página 16)

Wavecom Instruments Fully Integrated Test n Print Unit User Manual

Leakage Test Time

The leakage test time is USER adjustable. You may need to adjust timing in this feature if the DUT has a long

power up time or requires special power on procedure. Default time for Leakage Test is 20 seconds. From this

menu you can change the test time from 5 seconds to 28800 seconds. Adjusting to any less than 5 seconds will

put the test time to infinite.

 Press the key to increase the test time.

 Press the key to decrease the time.

 Press the key to set the new leakage / power test time.

 Press the key to escape out of the menu. No changes saved.

Audio Option - All TnP models

Enabling the audio option will make the TnP use a sound to indicate a pass or a fail at the end of a test. If the

TnP unit has never been altered then the audio beep is disabled.

 Press the key to disable.

 Press the key to enable.

Result Hold time option - all TnP models

Note Carefully: This setting will change the default display times and will remain until user re-sets to another

preferred value.

The feature enables the user to change the displayed time of the Test Result from approx. 1 – 90 seconds.

To enable Result Hold time option, from Main menu A, hold ENTER key and press F2 key. Release ENTER

key. Further pressing F2 key four times cycles you to the Result Hold setting screen. Pressing ENTER key (OK)

will display the settings page. Select your preferred timing by pressing F2 or F3 buttons ( Increase or Decrease)

as observed on the LCD screen.

Once the required result is shown on the LCD screen, press the ENTER key to lock new Result Hold time. The

TnP-500 will return to Main menu A.

Please note: as a further convenience, if Result Hold time during normal testing needs to be reduced, simply

press the ENTER key to rapidly move to the next test sequence. Alternative, is to re-set the Result Hold setting

again, as above.

Label Options - Only on Selected Memory Models

Changing the label options changes the way the printer behaves or how the tag is printed. When selecting this

option you will be prompted with 3 different options. Enable / Disable, Choosing a label set and modify the due

date.

Enable / Disable

Selecting this option will enable or disable the tag information being sent to the zebra printer. The printer can

also be disabled by switching the printer off from the power switch located on the side of the printer. Once the

printer is switched back on it will not print out the records that were created while the printer was switched off.

 Press the key to disable.

 Press the key to enable.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

Sem comentários

Wavecom TT040-50 Manual do Utilizador Página 16