Wavecom TT040-50 Manual do Utilizador descarregar pdf (Página 12)

Wavecom Instruments Fully Integrated Test n Print Unit User Manual

Adding a User

Screen

Instruction

New Barcode

0000000 5000

From the initial screen, press F2. Don't hold the F key, this will select a different

function.

Users 1 - 3

The TnP can hold up to 6 users. To scroll through the users, press enter. 3 sites

will be shown on each screen. Each site corresponds to an "F" key, for example

User 1 = F1. To edit a user, hold the corresponding "F" key for 2 seconds.

Edit User X ALP

Entering a user is the same process as entering a site, please refer to the Adding a

Site steps above, Note: The user name will not appear on the initial screen once

selected.

Users 1 - 3

User 1

User 2

User 3

Once a user has been entered, the 'F' buttons are used to select the user. For

example to select user 1, F1 would be pressed.

Auto Generate Barcode Function

If required the auto generate barcode number can be set before testing. The auto generate is always displayed

in the bottom left hand corner of the new barcode screen.

Screen

Instruction

Site x

New Barcode

0000000 5000

The TnP incorporates an auto generate barcode function which allows barcodes

to be generated sequentially after a barcode has been specified, for example: the

specified barcode is 1000 so the next barcode to be generated will be 1001, 1002,

1003 etc. This can be accessed by holding F3 for 2 seconds on the Barcode Entry

screen.

Barcode Length:

Up 7 Digits

Down

Esc Set

Once the auto generate menu has been accessed, the user can specify how many

digits they want in the barcode. The auto generate function allows a minimum of

2 and a maximum of 7 digits in the barcode to be generated. To increase the

number of digits in the barcode, press F1. To decrease the number of digits in the

barcode, press F2. To proceed, press enter, or to return to the Barcode Entry

screen, press F3.

Set Barcode:

xxxxxxx

Esc Set

If enter was pressed, the user can now set the barcode that will begin the

sequence. Key in a barcode and press enter to continue, or F3 to return the

Barcode Entry screen.

Use Leading

Zeros

Enable Disable

If enter was pressed, the user can specify whether or not to use leading zeros in

the auto generated barcode. For example: If the user selected 7 digits in the

barcode and entered 1000 as the barcode, the barcode will be 0001000 if leading

zeros are enabled. To enable leading zeros press F3. To disable, press

enter. The current barcode that will be generated is displayed in the bottom left

hand corner of the Barcode Entry screen.

Site x

New Barcode

0001000 5000

The current barcode that will be generated is displayed in the bottom left hand

corner of the Barcode Entry screen.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Comentários a estes Manuais

Sem comentários

Wavecom TT040-50 Manual do Utilizador Página 12

Comentários a estes Manuais

Manuais e produtos relacionados com Leitores de códigos de barras Wavecom TT040-50