Wavecom G900 Manual do Utilizador descarregar pdf (Página 12)

Wavecom GSM Modem

This confidential document is the property of WAVECOM and may not be copied or circulated without permission

3. AT commands for Call Control

3.1. Dial command D

This AT command is used by the external application to establish a call.

For a data call, the application sends to the GSM module the following

ASCII string : (the bearer has to be selected before with the +CBST

command)

ATD<xyz> where <xyz> is the called phone number.

For a voice call, the application sends to the GSM module the following

ASCII string : (the bearer may be selected before, if not a default bearer is

used)

ATD<xyz>; where <xyz> is the called phone number.

The answer to the command is the following :

OK if the call succeeds, for voice call only

CONNECT <speed> if tthe call succeeds, for data call only, <speed>

takes the value negotiated by the GSM module.

BUSY if the called party is in communication

NO ANSWER if no hang up is detected after a fixed network

time-out

Please, notice that in case of international number, the local international

prefix has not to be set (usually 00) but need to be replaced by the '+'

character.

Example : to establish a voice call to Wavecom from another country,

the AT command shall be :

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 66 67

Sem comentários

Wavecom G900 Manual do Utilizador Página 12